Skip to main content

Full text of "Motorola V276 Repair Manual"

See other formats

Installing Motorola V276 Headphone Jack 


Installing Motorola V276 Headphone Jack 

Tools used in this guide 

• Spudger 

Step 1 - Battery 

• Locate the silver button near the bottom of the back of 
your phone. 

• Press the button with one hand while sliding the back 
cover of the phone away from the antenna. 

• The back cover should slide off easily. 

Step 2 

• Insert the spudger near one corner of the battery 
(preferably one furthest from the phone's antenna). 

• With a firm grip, gently lift the end of your tool up. The 
battery should easily raise out of its place. 

• Now that the battery is easy to get a hold it, use your 
hands to take the battery out of the phone. 

©2010 iFixit — CC BY-NC-SA 

Page 1 of 4 

Installing Motorola V276 Headphone Jack 

Step 3 

• Note the metal connections on the phone, which are 
now exposed with the battery removed. 

• There are corresponding metal connectors on the 
replacement battery. 

• When you install the battery, be sure both connectors 
are matched up. Otherwise, your battery will be unable 
to supply power to your phone. 

Step 4 - Headphone Jack 

• Use Spudger to remove rubber plug from upper left 
corner of the back of the phone 

©2010 iFixit — CC BY-NC-SA 

Page 2 of 4 

Installing Motorola V276 Headphone Jack 

Step 5 

• Using a Hex T6 screwdriver, remove the 4 screws 
holding the back plate of the phone in place 

Step 6 

• Using your hands, pull up on the back plate while 
pulling on the 3 side tabs to remove the back plate 

• Be careful when removing the back plate; 
don't put too much stress on the back plate 
or the plastic may snap 


© 2010 iFixit — CC BY-NC-SA 

Page 3 of 4 

Installing Motorola V276 Headphone Jack 

Step 7 

• On the back casing, using a spudger, push into the 
headphone jack at an upward angle to pop it out 

©2010 iFixit — CC BY-NC-SA 

Page 4 of 4